Cambridge-soundworks FPS2000 User Manual download pdf (Page 10)

REAR

RIGHT

6

F

Attaching The Floor Stands

by feeding it down the length

of the full length slot. At each

end, feed the cable through the

short notches (see diagram G).

2. Insert the satellite end of the

leg/cable assembly into the

middle socket of the apex joint.

Make sure the satellite cable

exits through the short notch

and not the full length slot

(see diagram F).

The rear satellites (with their

desktop stands attached) may be

installed in their floor stands.

1. One leg of each floor stand has

a full length slot, with short

notches opposite the slot at

each end. Insert a satellite

cable inside one of these legs

3. Insert the two solid legs into

the outside sockets in the

apex joint.

4. Position the two “cut-away”

sections of the desktop stand

over the opening in the top of

the apex joint, as shown in

diagram F. Be sure to align the

face of the stand with the face

of the apex joint. Lower the

stand straight down into the

apex joint.

5. Holding the ends of the apex

joint, push on the front of the

desktop stand until it slips back

into the slot in the apex joint.

Confirm a secure fit.

6. At the base of the rear leg,

gently pull on the satellite

cable to remove any

unnecessary slack in the cable.

7. Insert a rubber plug into the

base of each leg, taking care to

feed the cable out the short

notch in the rear leg (see

diagram H).

G

H

FPS2000 Rev.C 4/17/00, 4:09 PM10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments